Related Video
About this item
- Outstanding Brightness: The trailer light kit is equipped with high-quality 2835 and 5050 SMD LEDs. Both types of LEDs have the characteristics of stability and durability. At the same time, it can output sufficiently bright light. Make travel safer at all times.
- Easy Installation: The square lights are stud-mounted on the surface design, light with license light on the left, the other on right. The side marker light and the 16inch brake light bar are both installed using screws, as long as the screws on both ends are tightened.
- Wire Connections: Square light: White for ground, brown for running light, yellow for left turn and brake light, and green for right turn and brake light. 16 Inch brake light bar: White for ground, black for low brightness tail light, red for high brightness brake light. Side marker light: White for ground, black for positive.
- Highly Waterproof: These lights have a high sealed and waterproof design, effectively preventing moisture damage to the LED. Among them, each side of the square light is independent and has a water drainage notch, allowing water to flow out when entering the shell.
- Full Functions: Used as running light side marker light license light turn signals light parking light stop/brake light tail light. Perfect for 12V DC vehicles with max width of 80 inches. Fit most trailers, boats, trucks, RV, Marine, Pickups, camper, tractors, etc. bus, lorry, van, caravan, snowmobile utility trailers.
- All-in-one Kit: Include 2pcs square lights, 2pcs red and 4pcs amber side marker light, 1pc 16inch brake tail light bar, license plate bracket, 25ft length trailer wiring harness, the reflector and the different types of stainless steel mounting hardware. (For hardware instruction, please check picture9) 2 Years Warranty Honored by Nilight.
LED Trailer Light Kit
- Waterproof Rate: IP68
- Operating voltage: 12VDC / Amperage Draw: 0.03A-0.37A
- Amber/ Red side marker light: 2.48in x 0.9in x 0.69in
- Red trailer light bar dimension: 15.6in x 1.2in x 0.5in
- Square Light dimension: 5.12in x 4.57in x 2.56in / Square light mounting distance: 2.76in
Main Advantages
Outstanding LED
The trailer light kit is equipped with high-quality 2835 and 5050 SMD LEDs. Output sufficiently bright light. More stable and durable.
Special Design
Stud mounting for easy, firm, and durable installation. Grooves designed for perfect surface mounting. Square light mounting distance: 2.76in.
Highly Sealed
Front lens of the red trailer light bar is sonically welded, back wire is also added on glue for a complete sealed. Center hole size is: 14mm x 14mm.
Additional Hardware
Come with all the accessories required for installation. Please refer to the attached instruction manual for detailed usage.
Multi-functions
The square light includes 5050 and 2835 SMD LEDs. Multi-functions: red running light stop turn light, white license light, and side marker light.
Two Brightness Modes
The red trailer ID bar has two brightness levels. Low brightness is for tail light, high brightness is for stop/brake light. White wire for ground, black wire for low brightness tail light, and red wire for high brightness brake light.
Excellent Brightness
The 2.5-inch amber and red lights also work as front, side and rear marker lights or clearance lights.
Built-in IP68 Waterproof
Inside electronics and circuit board are epoxy encased and fully sonically sealed and submersible, trailer light housing also has water drainage.
